Pull Out Cart
General
If any flaws, or damage are detected with the part assembly, the material handler robot will place the part onto the Pull Out Cart. Once the part is on the cart, personnel will pull out the cart and begin to verify the part is free of any damage or wear. If damage or wear is found, personnel can remove the part from the cart by using the lift assist device.
The Pull Out Cart is located at Station 80, by the Unified Lift Assist.
Major Components
The Pull Out Cart features the following components.
| Item | Description | Function |
|---|---|---|
| A | Part Fixture | Allows for the material handling robot to place the rearwall assembly for the operator to inspect or remove part. |
| B | Laser Sensor | Detects when the Pull Out Cart is in position and for part present status. |
| C | I/O Module | Manages the inputs and outputs of the cart's control system, sending signals between the cart and the Programmable Logic Controller (PLC). |
| D | Lock Pin | Locks the cart into place at the station through the cart rails that the cart is placed over. |
