Turntable
General
There is one (1) CR1300 turntable located in the 2V13 Sub Floor Cross Member Cell at Station 010, made by Weiss.
The turntable has two (2) Geo Fixtures attached to the top. The turntable allows both the operator or robot to easily access all Geo Fixtures by rotating the table to the properly position for access. When the operation is completed, the turntable rotates and the process is completed. To rotate the Geo Fixtures, the turntable features a Siemens SIMOTICS servo motor that allows for the turntable to rotate to the correct position.
Major Components (CR1300)
The turntable features the following components.
| Item | Description | Function |
|---|---|---|
| A | Service Union | The service union allows for all incoming air to be distributed to required equipment such as manifolds, clamps, etc. |
| B | Position Sensors | Detects the position of the turntable. There are 5 positions: All Stop, P1 Position, P2 Position, P3 Position, and P4 Position. These sensors are attached to a Murrelectronik fieldbus I/O panel to send signals back to the system CPU. |
| C | Metal Bellows Coupling | Flexible coupling connecting the motor shaft to the turntable shaft. |
| D | Servo Motor | Siemens SIMOTICS 1FT7108-5AC71-1CH1 synchronous motor that allows Allows for turntable to rotate to the required working position. |
| E | Vent Screw | Used to relieve build-up pressure or allow air to escape from the interior of the rotary table during operation. |
| F | Cover of Shaft | Used for hand cranking the shaft, if necessary. |
| G | Sight Glass | Used to check the oil level for the turntable. |
